McCulloch aftermarket reproduction molded fuel line and filter. Replaces part Numbers 64848, and 215708 for 10-10 saws and almost all of the 10 series line.

Please Note: The hole your fuel line goes through in the side of the tank can vary in size slightly from saw to saw. With the new line being softer and more pliable than old original dried out line it may feel a little less snug. If that's a concern, a couple wraps of teflon tape will provide a more snug fit. My personal preference (taught to me by Jereme Bell) is to use a little Seal All where it goes through the port. This can be found at most automotive parts stores and also available for less than $4.00 per tube at fleet type stores https://www.farmandfleet.com/products/840921-seal-...

See picture below :